Based from official firmware V2.8.2
- Replaced the booting music with a single bip
- Improved homing speed
- Improved auto leveling speed marginally
- Improved booting speed (side effect of booting music)
- Reduced motherboard fan noise
- Slightly increased printing speed (acceleration and jerk) when not defined in slicer
Additional details:
- Enabled quick home (X and Y homes at the same time)
- Raised homing speed to 65mm instead of 50mm and 8mm instead of 5mm for Z
- Set default fan speed to 5 instead of 255 and idle to 3 instead of 0
- Raised max acceleration to 2000 instead of 600 (be careful with that)
- Increased default acceleration to 700 instead of 600
- Increased default jerk to 6mm instead of 5mm
- Raised probing speed to 150mm instead of 133mm and 8mm instead of 4mm for Z
- Lowered Z clearance when probing to 2mm instead of 5mm
- Lowered Z homing height