Releases: jojos38/anycubic-kobra-improved-firmware
Releases · jojos38/anycubic-kobra-improved-firmware
v1.2
This is a beta, based from official firmware V2.8.2
READ THIS
You may experience layer shifting with this Linear Advance enabled version! If you do so please use the v1.1 version which doesn't have Linear Advance enabled by default OR disable Linear Advance manually by setting the K value to 0 (M900 K0 and then M500)
- Tweaked some thermal settings to reduce false thermal issue positives
- Enabled Linear Advance (/!\ Might cause layer shifting!)
v1.1
Based from official firmware V2.8.2
- Replaced the booting music with a single bip
- Improved homing speed
- Improved auto leveling speed marginally
- Improved booting speed (side effect of booting music)
- Reduced motherboard fan noise
- Slightly increased printing speed (acceleration and jerk) when not defined in slicer
Additional details:
- Enabled quick home (X and Y homes at the same time)
- Raised homing speed to 65mm instead of 50mm and 8mm instead of 5mm for Z
- Set default fan speed to 5 instead of 255 and idle to 3 instead of 0
- Raised max acceleration to 2000 instead of 600 (be careful with that)
- Increased default acceleration to 700 instead of 600
- Increased default jerk to 6mm instead of 5mm
- Raised probing speed to 150mm instead of 133mm and 8mm instead of 4mm for Z
- Lowered Z clearance when probing to 2mm instead of 5mm
- Lowered Z homing height