Skip to content

Punch firewall holes to connect TCP, SCTP and UDP between network peers

Notifications You must be signed in to change notification settings

vanrein/SocketSynergy

Folders and files

NameName
Last commit message
Last commit date

Latest commit

 

History

12 Commits
 
 
 
 
 
 
 
 
 
 
 
 
 
 

Repository files navigation

README for SocketSynergy

SocketSynergy helps to connect peers behind firewalls. It is a generic solution to a problem that most peer-to-peer applications run into.

From: Rick van Rein rick@openfortress.nl

Purpose

The intention of SocketSynergy is to allow peers to connect in spite of both being behind a firewall. This is traditionally considered impossible, because always one of the firewalls blocks. That is a problem for peer-to-peer applications, but SocketSynergy makes it possible. And easy, all it takes is another call synergy() on top of the general Socket API.

The assumptions made by SocketSynergy are

  • transparent addressing
  • firewalls following the general BEHAVE WG specifications

Specifically note: There is no support for Network Address Translation. If we want the network to function, we should rely on IPv6. Do have a look at the other elements in the P2P Toolkit to learn how reasonable this assumption is.

Quickstart demo

Following is a quick intro showing how to use the synergy() library call and, perhaps one day, syscall.

Listen for a particular peer::

./listendemo tcp 2001:db8:420a:1::11 4444 2001:db8:420a:1::5 5555 3

This creates a TCP listening socket on the first address/port that accepts incoming connections from the second address/port. In fact that is very close to what a tool like netcat6 can do.

However, the trick is in the last parameter, 3 in this case. This is the hoplimit for an initial SYN message sent out. The idea is that the value of the last parameter is the number of steps to get outside of the last firewall shielding the local network from incoming initiative. The SYN should be dropped as soon as it has crossed that last firewall, so that all ports are open. Meanwhile, the listendemo is a listening socket, so it awaits incoming connections. Punching the hole first makes it accessible from the specified host, that's all.

It is now possible to connect from the specified peer, using some standard tool like netcat6::

nc6 -6 -s 2001:db8:420a:1::5 -p 5555 2001:db8:420a:1::11 4444

It is also possible to do the same things based on UDP. Just give a first argument udp to listendemo and add a -u option to the nc6 commandline. Likewise, SCTP is possible.

Of course, with UDP there are no sharp boundaries to the start and end of a session. The trick used to open the port is sending out a UDP packet that, once again, drops as soon as it has crossed the last firewall protecting this domain.

The real trick here is knowing the number of hops to get to the big, bad Internet. This should not be taken too low (as it would not punch the desired hole) and not too high (as some nearby remote firewalls might receive it and respond with RST, causing the incoming firewalls to close the just-punched hole).

Code reference

This code was written based on RFC 2292, "Advanced Sockets API for IPv6", by W. Stevens and M. Thomas.