This is a P8X32A/Propeller, P2X8C4M64P/Propeller 2 driver object for the Sensirion SHT3x (30, 31, 35) combination temperature and relative humidity sensors.
IMPORTANT: This software is meant to be used with the spin-standard-library (P8X32A) or p2-spin-standard-library (P2X8C4M64P). Please install the applicable library first before attempting to use this code, otherwise you will be missing several files required to build the project.
- I2C connection at ~30kHz (P1: bytecode-based I2C engine), up to 1MHz (P1: PASM-based I2C engine, P2: max tested speed 840kHz)
- Measurement in one-shot (with clock-stretching) or continuous modes
- Supports all three measurement repeatability modes and five data rates
- On-chip heating element operation
- Reading the sensor's serial number
- Supports alternate slave address
- Set interrupt thresholds
- Optional reset pin
P1/SPIN1:
- spin-standard-library
- 1 extra core/cog for the PASM I2C engine (none if the bytecode-based I2C engine is used)
sensor.temp_rh.common.spinh(source: spin-standard-library)
P2/SPIN2:
- p2-spin-standard-library
sensor.temp_rh.common.spin2h(source: p2-spin-standard-library)
| Processor | Language | Compiler | Backend | Status |
|---|---|---|---|---|
| P1 | SPIN1 | FlexSpin (6.9.4) | Bytecode | OK |
| P1 | SPIN1 | FlexSpin (6.9.4) | Native/PASM | OK |
| P2 | SPIN2 | FlexSpin (6.9.4) | NuCode | Untested |
| P2 | SPIN2 | FlexSpin (6.9.4) | Native/PASM2 | OK |
(other versions or toolchains not listed are not supported, and may or may not work)
- TBD