You signed in with another tab or window. Reload to refresh your session.You signed out in another tab or window. Reload to refresh your session.You switched accounts on another tab or window. Reload to refresh your session.Dismiss alert
[23265.590005] usb 1-1.2: new full-speed USB device number 32 using ehci-pci
[23265.700783] usb 1-1.2: New USB device found, idVendor=0483, idProduct=5711
[23265.700791] usb 1-1.2: New USB device strings: Mfr=1, Product=2, SerialNumber=3
[23265.700796] usb 1-1.2: Product: STM32 virtual serprog for flashrom
[23265.700800] usb 1-1.2: Manufacturer: flashrom
[23265.700805] usb 1-1.2: SerialNumber: 114209875182525052FF6B06
[23265.778871] cdc_acm 1-1.2:1.0: ttyACM0: USB ACM device
[23265.779150] usbcore: registered new interface driver cdc_acm
[23265.779151] cdc_acm: USB Abstract Control Model driver for USB modems and ISDN adapters
But if I try to compile and flash from the sources (latest master of 2018-01-28 1996dd1), the board does not initialize correctly Usb serial:
[23449.341587] usb 1-1.2: new full-speed USB device number 35 using ehci-pci
[23454.492855] usb 1-1.2: unable to read config index 0 descriptor/start: -110
[23454.492869] usb 1-1.2: can't read configurations, error -110
[23454.577516] usb 1-1.2: new full-speed USB device number 36 using ehci-pci
[23454.657511] usb 1-1.2: device descriptor read/64, error -32
Do you still have source snapshot of Jan 8?
The text was updated successfully, but these errors were encountered:
There is a binary release v.1.0 of 2019-01-08: https://github.com/wosk/stm32-vserprog-lpc/releases/download/v1.0/stm32-vserprog-lpc.hex
I have flashed this version into STM32 "blue pill" STM32F103C8T6 and it seems to boot fine and initialize USB serial:
But if I try to compile and flash from the sources (latest master of 2018-01-28 1996dd1), the board does not initialize correctly Usb serial:
Do you still have source snapshot of Jan 8?
The text was updated successfully, but these errors were encountered: