LEDs Turns on and off one after the other in a regular sequence. See PCB Design, Schematic and Gerber Files.

A CLI Tool to automate the generation of ALL the required drilling, cutting and trace engraving Gcode files, given ONLY the Gerber files. Also supports the Simulation of tool paths.

16-digit display module, based on the tm1640 multiplexer chip (0.56" 7-seg digits with dp)

Dual buffered 1:3 multiples with bipolar signal indicator lights.

A custom prototyping board with 976 points arranged like a breadboard, that fits inside a 10cm×11cm PCB

Digital clock based on AVR microcontroller and 7-segment indicator

Miniature driver board, case & software.

This repository contains the projects I completed during the Platzi course on PCB design.

PCB drilling problem on PCB board using tabu search algorithm.

Development boards for hardware used in Arduino projects

Non-interactive scripts to help you generate (Gerber, drill, PNG) files out of KiCad (electronics) projects

Open source 7 segment serially controlled led display that fits inside a generic 45x26mm panel mount plastic enclosure. Upgrade your function specific panel meter PCB with a new one controllable by your preferred MCU.

Simple CAN Bus PCB designed for 8x CAN nodes, 2A power delivery and spring type connectors

ATTiny85 Arcade schematic, gerbers and games

Sends the CO2 value received from the Senseair S8 sensor using nRF24l01

NE555 timer was launched in 1971 and has a history of 50 years. It is easy to use, stable and cheap, so it is still widely used, and its output in 2003 was 1 billion. Now I use NE555 to make timers. Most of the control parts of electronic door locks use this circuit. The timing method is very simple, 1.1 x RC, which is not very accurate compared…

A simple but versatile bus board for modular synthesizers in the Eurorack format. Cheap and easy to build and with many slots for connecting modules with both 10-pin and 16-pin connectors.

UDOO shield for XBEE and NFC module by Adafruit.

A CNY-70 based Line Sensor Board