You signed in with another tab or window. Reload to refresh your session.You signed out in another tab or window. Reload to refresh your session.You switched accounts on another tab or window. Reload to refresh your session.Dismiss alert
Potree point cloud measured units always match that of the point cloud, however the label always states 'm' for meters. When measuring a State Plane coordinate system in feet, the measurement numbers are correct but the label is wrong.
What should be the expected behavior?
Either remove the label or find an adjustment to recognize the CRS as either feet or meters
How can we reproduce this? (What steps did you do to trigger the problem? Be detailed)
Use Potree 3D measuring tools against a point cloud that has been projected from UTM to State Plane Feet (ie Colorado Central ESPG: 0502)
The text was updated successfully, but these errors were encountered:
What is the problem?
Potree point cloud measured units always match that of the point cloud, however the label always states 'm' for meters. When measuring a State Plane coordinate system in feet, the measurement numbers are correct but the label is wrong.
What should be the expected behavior?
Either remove the label or find an adjustment to recognize the CRS as either feet or meters
How can we reproduce this? (What steps did you do to trigger the problem? Be detailed)
Use Potree 3D measuring tools against a point cloud that has been projected from UTM to State Plane Feet (ie Colorado Central ESPG: 0502)
The text was updated successfully, but these errors were encountered: